OUT OF STOCK
DesignerGrips© are available for any pistol model listed
in the Tractiongrips category. Also available are Universal sets, which includes two pieces that are
approximately 1.5" by 4" long each.
The DesignerGrips© material is smooth and will not add texture
to the weapon, but it is so thin, the factory checkering can usually be felt through the material when properly installed.
A hair dryer or heat gun is required to install the DesignerGrips©. To install, you simply clean the surface
where the grips will be applied with hot water and a drop of dish soap, dry thoroughly, then stick the grips on, and heat
them with a hair dryer. Once the grips are heated, you just press them firmly against the surface, and the material
will form to the surface.